Search:

Type: Posts; User: BAXTC1

Page 1 of 12 1 2 3 4

Search: Search took 0.05 seconds.

  1. Replies
    2
    Views
    2,295

    Well, they can roll flightless birds. :-) ...

    Well, they can roll flightless birds. :-)

    Thinking of going down through Clare, Gawler and Williamstown to Birdwood for a look around the motor museum, I haven't been there for about ten years....
  2. Replies
    2
    Views
    2,295

    Suggestions for weekend ride in S.A

    Thinking of a ride next weekend (Fri 6 to Mon 9 October.
    I'm on the Eyre Peninsula, any suggestions? Probably looking to go east/south east if anyone knows of a good ride.
  3. Replies
    19
    Views
    4,047

    Before you pull anything apart, just try putting...

    Before you pull anything apart, just try putting it in gear and see if the noise goes away as you release the clutch. put the brake on (front or rear, doesn't matter) and load up the drive. In my...
  4. Replies
    19
    Views
    4,047

    No, the oil screen is under the engine, alongside...

    No, the oil screen is under the engine, alongside the oil filter. It screens the oil to remove larger particles before the oil goes into the pump and through the filter. If you remove it, you will...
  5. Replies
    19
    Views
    4,047

    If you drain the oil, take off the screen from...

    If you drain the oil, take off the screen from the bottom of the motor, I could almost guarantee that you will find a lot of crumbled material from the clutch housing bushes. The bikes will still run...
  6. Replies
    19
    Views
    4,047

    Have a look back through some old threads about...

    Have a look back through some old threads about the gpx, you should find a few about the noise, might even find a sound recording or two. I'd bet my left nut on clutch housing. ��
    Edit: With regards...
  7. Replies
    19
    Views
    4,047

    Sounds like a standard case of clutch housing...

    Sounds like a standard case of clutch housing knock to me, not surprising at those kms. If you remove the oil screen, i suspect you will find a lot of material there that used to be the clutch...
  8. I think you will find the brake lines will be the...

    I think you will find the brake lines will be the same between the year models. One thing to watch for, when I bought the lines for mine, the rear brake line did not have a bend in the banjo fitting...
  9. Thread: GPZ 250 1984

    by BAXTC1
    Replies
    4
    Views
    1,426

    I didn't realise they were a grey import, I...

    I didn't realise they were a grey import, I thought they were sold here. This is the model that the GPX250 eventuated from, so some of the basic parts might be able to be sourced from there. I have a...
  10. Replies
    13
    Views
    2,494

    I have never ridden a bike with abs, so to me...

    I have never ridden a bike with abs, so to me when buying a bike it is neither here nor there. I recently bought a V Strom 650. During my searching I found a couple with abs in my price. I chose the...
  11. Replies
    13
    Views
    2,494

    Either that, or give me his number, my wife is...

    Either that, or give me his number, my wife is looking for one. :-)
  12. Replies
    1
    Views
    680

    I don't know the model, but being 1992 I would...

    I don't know the model, but being 1992 I would guess at it being a H4, only a guess mind you. Best way is to take one out and have a look, then you will know for sure.
  13. Replies
    13
    Views
    2,494

    $4,400 sounds pretty cheap for a 2014 300 with...

    $4,400 sounds pretty cheap for a 2014 300 with abs and low ks, I would be wary of the reason for the low price. Is there something he is not telling you?
  14. Replies
    14
    Views
    2,428

    Yep, drain the oil out, that is what the hose is...

    Yep, drain the oil out, that is what the hose is for.
  15. Replies
    14
    Views
    2,428

    One hose would be the battery breather, one would...

    One hose would be the battery breather, one would be the fuel tank drain (to drain water or spilled fuel from around the fuel cap). These hang down the bottom, you should see a loop connected to the...
  16. Replies
    14
    Views
    2,428

    The headlight will only come on after the starter...

    The headlight will only come on after the starter button has been pressed, engine running or not.
    It sounds like you have a bad connection in one of your leads. Start at the battery and clean and...
  17. Replies
    59
    Views
    7,627

    Found a cylinder from a 2007 with 2738 miles on....

    Found a cylinder from a 2007 with 2738 miles on.
    Got it for a reasonable price, had the bores honed and have fitted it along with the "paperweight" pistons and rings I bought last year.
    Also put in...
  18. Screw a bit small for ezy out? I would go with...

    Screw a bit small for ezy out?
    I would go with drilling the head off and work the remainder of the screw.
    If it all goes to ****, I have a master cylinder here if you need it.
  19. Thread: Engine help

    by BAXTC1
    Replies
    4
    Views
    852

    This might be of some help....

    This might be of some help.
    https://www.ninjette.org/forums/showthread.php?t=112032&highlight=newgen+engine+pregen
  20. Replies
    4
    Views
    557

    The sight glass will simply push out from inside,...

    The sight glass will simply push out from inside, easy to do with the clutch cover off, though I haven't tried with the cover on the bike. If you can get the sight glass out (make sure the bike is on...
  21. Replies
    4
    Views
    557

    The sight glass will simply push out from inside,...

    The sight glass will simply push out from inside, easy to do with the clutch cover off, though I haven't tried with the cover on the bike. If you can get the sight glass out (make sure the bike is on...
  22. Replies
    22
    Views
    2,647

    They are in the back of the clutch housing...

    They are in the back of the clutch housing (basket). Not replaced as service items, just replace the housing as a unit. Some people do go to the trouble of drilling out the rivets, cutting new bushes...
  23. Replies
    22
    Views
    2,647

    That, sir, is your clutch housing bushes. Either...

    That, sir, is your clutch housing bushes. Either you have clutch knock, or housing has been replaced.
  24. Replies
    22
    Views
    2,647

    I just used metho, sealed with ultra grey...

    I just used metho, sealed with ultra grey silicone.
  25. Replies
    22
    Views
    2,647

    Yes, the bottom case comes away leaving...

    Yes, the bottom case comes away leaving everything in the top case. A couple of things to watch for, the oil supply pipe, make sure you unhook it from the lower case (and hook it bach up when you...
Results 1 to 25 of 283
Page 1 of 12 1 2 3 4
Powered by vBulletin® Version 4.1.12
Copyright © 2019 vBulletin Solutions, Inc. All rights reserved.
Extra Tabs by vBulletin Hispano
All times are GMT +10. The time now is 06:53 AM.
vBulletin 4.0 skin by CompleteVB
Your continued use of this forum constitutes your acceptance of the Forum Rules and Terms and Conditions.